Skip to content
Home » General » ELF MADE STAMP STL FROM SANTA CLAUS THE MOVIE

ELF MADE STAMP STL FROM SANTA CLAUS THE MOVIE

So I was watching Santa Claus the Movie…you know, that old movie from the 80s:
https://www.imdb.com/title/tt0089961/

In the movie, the Elves have this stamp that they stamp onto each of the toys they make…and in having little ones, I needed to get my hands on it.

Coincidently enough, I couldn’t find it online, as an STL….so I had one made, and want to give it to you as a Gift.

Elf Made Stamp STL


You can download it here:
https://tacticalware.com/downloads/Elf_Made.zip

Or directly from Thingiverse at:
https://www.thingiverse.com/thing:4685864

Hardware that I used to print it:
Ender 3 Pro
https://amzn.to/3qZQTks

Hotend
https://amzn.to/37iIrVW

Tubing
https://amzn.to/2IQ8V7N

eSun Black PLA+ (For the Handle)
https://amzn.to/37gdSjs

TPU (For the Stamp)
https://amzn.to/3mmCOdB

And I have the following gear in place running Octoprint:
Raspberry Pi 4 (4gb)
https://amzn.to/3q551IO

SanDisk 32GB Ultra microSDHC UHS-I Memory Card with Adapter
https://amzn.to/2Vfvo0y

CanaKit 3.5A Raspberry Pi 4 Power Supply (USB-C)
https://amzn.to/3fNTYPu

CanaKit Raspberry Pi 4 Micro HDMI Cable – 6 Feet
https://amzn.to/33u5hr9

Western Digital 500GB WD_Black SN750 NVMe
https://amzn.to/3nZ5pH4

Plugable USB C to M.2 NVMe Tool-free Enclosure
https://amzn.to/3lflV3L

The most important thing is after you setup your system, before you print this stamp, is to calibrate your system for these filaments. You will need to do it for both the PLA+ and the TPU. For that, you can refer to these pages:
Configure your Extrusion Multiplier:
https://tacticalware.com/ender-3-pro-simplify3d-configuring-the-extrusion-multiplier/

Confirm your heat settings:
https://tacticalware.com/3d-printing-heat-tower/

Thanks for reading!