I am in the process of putting together several posts, which detail my printer hardware, along with giving you a copy of my FFF profile for that setup. For this post I am using Simplify3D to Slice eSUN’s PLA+ in Black, on a Creality Ender 3 Pro with a Direct Drive setup, using a Micro Swiss Hotend.
Slicer Profile can be downloaded here:
Hardware that I used:
Ender 3 Pro
And I have the following gear in place running Octoprint:
Raspberry Pi 4 (4gb)
SanDisk 32GB Ultra microSDHC UHS-I Memory Card with Adapter
CanaKit 3.5A Raspberry Pi 4 Power Supply (USB-C)
CanaKit Raspberry Pi 4 Micro HDMI Cable – 6 Feet
Western Digital 500GB WD_Black SN750 NVMe
Plugable USB C to M.2 NVMe Tool-free Enclosure
The most important thing is after you setup your system, you will need to dial it in. For that, you can refer to these pages:
Configure your Extrusion Multiplier:
Confirm your heat settings:
Thanks for reading!