BlockErupter Setup On A Raspberry Pi
Setup a USB Block Erupter on the Raspberry Pi with MinePeon
Insert your MinePeon SD Card
Connect the Rashberry Pi to a Powered USB Hub
Connect the Block Erupters into the Powered USB Hub
Boot the Raspberry Pi
Log into the Pi as user: minepeon with the password: peon
Type ifconfig and note the ip address for the device
On a separate computer open up your internet browser and point it to the ip of the raspberry pi. (ex: http://192.168.1.101)
Log into the Pi as user: minepeon with the password: peon
Click on the Pools tab at the top of the page
Delete all the info inside the boxes and replace it with your own info
Ex: stratum.d7.lt:3333 username: InstantSupp.777 password: 12345
Click Submit
The Block Erupter will now start mining
After a few minutes check the Graph page to make sure it is producing the info and your erupter is mining properly
Thanks for reading
Hardware that I use:
Raspberry Pi 4 (4gb)
https://amzn.to/3q551IO
SanDisk 32GB Ultra microSDHC UHS-I Memory Card with Adapter
https://amzn.to/2Vfvo0y
CanaKit 3.5A Raspberry Pi 4 Power Supply (USB-C)
https://amzn.to/3fNTYPu
CanaKit Raspberry Pi 4 Micro HDMI Cable – 6 Feet
https://amzn.to/33u5hr9
Western Digital 500GB WD_Black SN750 NVMe
https://amzn.to/3nZ5pH4
Plugable USB C to M.2 NVMe Tool-free Enclosure
https://amzn.to/3lflV3L
