NVIDIA 1080 TI DRIVER INSTALL ON PARROT OS
This is a tricky one. Getting your NVidia 1080 Ti drivers installed and running on Parrot OS can be a pain. These directions are how to install them on a bare metal system
Open a terminal
Type:
sudo bash
Enter your password
nano /etc/modprobe.d/blacklist-nouveau.conf
Add the following to the file:
blacklist nouveau
blacklist lbm-nouveau
options nouveau modeset=0
alias nouveau off
alias lbm-nouveau off
Save the file, exit, and reboot your system
Once back on the desktop
Open a terminal
Type:
sudo bash
Enter your password
apt-get update && apt install nvidia-driver
Type y when prompted
reboot
Once back on the desktop
Open a terminal
Type:
sudo bash
Enter your password
apt install -y ocl-icd-libopencl1 nvidia-cuda-toolkit
Type y when prompted
reboot
Once back on the desktop
Open a terminal
Type:
sudo bash
Enter your password
nvidia-smi – this will show your card now
hashcat -b – this will run hashcat for your system to show benchmarks
That’s it!
The hardware that I used in this guide:
Gigabyte AORUS GeForce GTX 1080 Ti (QTY 6):
https://amzn.to/2JqvXC8
Motherboard (QTY 1):
https://amzn.to/2JqGJZ7
CPU (QTY 1):
https://amzn.to/3qevp2X
Memory (QTY 1):
https://amzn.to/2JqHn8Z
Hard Drive (QTY 1):
https://amzn.to/3lic3X5
Risers (QTY 6):
https://amzn.to/33rIgVE
Power Supplies (QTY 2):
https://amzn.to/3fTRpLR
Add2PSU (QTY 1):
https://amzn.to/39s4URY
Power Switch (QTY 1):
https://amzn.to/3ljmNVk
